Tripp Lite B118-002 TV Cables User Manual


 
4
Cascaded Installation Instructions
Note: The maximum distances referenced in these instructions have been tested at a video
resolution of 1080p (60Hz) with 36-bit (12-bits per channel) Deep Color using 28AWG HDMI
cables. Longer distances between the splitter and connected monitors are achievable using 24AWG
HDMI cables and/or a source that is set to display a lower video resolution.
1
 Makesurethatthepowertoalldevicesthatyouwillbeconnectingis
turned off.
2
 ConnecttheHDMIsourcetotheInputportontherstlevelsplitter.
Note: The length of the HDMI cable connecting the source to the splitter must not exceed
13 ft. (4 m).
3
 ConnectanavailableOutputportontherstlevelsplittertotheHDMI
input port on a second level splitter.
Note: The length of the HDMI cable connecting the first and second level splitters must not
exceed 16 ft. (5 m).
4
 Repeatstep3foreachadditionalsplitterthatyouwishtoadd,adding
nomorethan6levelsofsplitters.
5
 ConnectanavailableOutputporttotheHDMIinputportofyourdisplay.
Note: The length of the HDMI cable connecting the splitter to the display must not exceed
16 ft. (5 m).
6
 Repeatstep5fortheremainingOutputportsintheinstallation.
7
 Connecttheincludedpowersupplytoeachsplitter,andthenplugit
intoaTrippLiteSurgeSuppressor,PowerDistributionUnit(PDU),or
UninterruptiblePowerSupply(UPS).
8
 TurnonthepowertotheHDMIsourceanddisplays.
13-07-120 93-32BD.indd 4 8/2/2013 4:04:44 PM