Filter
Top Products
6
5.3 Mounting Rails
5.4 Adjusting Mounting Rail Depth
The enclosure comes with mounting rails that have square holes for mounting rack equipment. To
install equipment, use the included cage nuts and other hardware. (See page 7 for installation of
cage nuts.) Warning: Be sure to have the enclosure in its final position on the floor before
mounting any equipment inside. Also be sure to have all the right adjustments on your rails
before mounting equipment. (See below for Adjusting Mounting Rail Depth.)
Warning: Do not attempt to adjust rails while equipment is installed in the enclosure.
Do not attempt to use rails without screws installed. (2 per rail.)
The 4 mounting rails are pre-installed to accommodate equipment with a mounting depth of 20.5
inches (521 mm). Do not adjust the mounting rails unless your equipment requires a different
mounting depth. The front and rear sets of rails can be adjusted independently for mounting of
equipment with depths between 3 inches (76 mm) and 32.5 inches (826 mm).
1
Each rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper
corner and another in the lower corner. Using a Phillips-head screwdriver, remove the screws
that fasten the rails to the enclosure.
2
Move cage nuts to desired depth and reinstall.
3
Slide the mounting rails to the desired depth and reattach them using the screws you removed
in Step 1.
5.2 Reversing the Doors
5. Enclosure Configuration
5.1 Door Locks
The front and back doors have locks that are accessible by the included keys.
Each side panel locks using an L-shaped lever on the inside of the enclosure.
1
To unlock and remove the side panels, lift the shorter leg of the “L” up and pull it away from the side panel. Pull the tab on the side panel and
remove it from the enclosure.
2
To re-lock the side panels, secure it in the proper position, lift the shorter leg of the “L” up and push it toward the side panel, back into the hole that it was
in initially. Once it is in place, push the shorter leg of the “L” down to lock it. Note: To lock and unlock the side panels, you will need to have access to the
interior of the enclosure.
The doors of the enclosure are held in position on the enclosure’s frame with two spring-loaded pins. To reverse the door’s swing direction, simply
release the pins by pulling them up (lower pin) or down (upper pin) and remove them from the mounting holes on the frame of the enclosure.
Flip the door in the opposite direction and replace the pins in the identical mounting holes on the other side of the enclosure’s frame by lining them up
with the mounting holes and engaging them again.
1
2
3
1 2
A
B
A
B