Filter
Top Products
26
PROGRAMMING CHANNEL CONTROL LOCK
By default,the remote control’s channel-control capabilities
are locked to the cable converter. The affected keys* are
0~9,CH+,CH-,ENTER,and LAST.This will guarantee that
you do not inadvertently change a channel on your TV or
VCR.However,you can de-activate this feature to allow full
access to these keys in the TV and VCR modes.
*NOTE: This feature does not affect the AUD mode.
To De-Activate Channel Control Lock:
1. On the remote control,press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
2. Enter 9-7- 3.The CBLkey will blink twice.
3. Press CH- once. The CBL key will blink
four times.
4. Now,the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.
To Re-Activate Channel Control Lock:
1. On the remote control,press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
2. Enter 9-7- 3.The CBLkey will blink twice.
3. Press CH+ once. The CBL key will blink twice.
4. Now,regardless of what mode you select
(except AUD),only the channel control
capability of your cable converter will be
accessible.
Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 26