Filter
Top Products
30
RE-ASSIGNING DEVICE KEYS
The Atlas DVR/PVR 5-Device Universal Remote Control
can be set up to control a second device.For example,
to have the unit control a TV,a Cable Converter,and two
DVD Players,you will need to re-assign the unused AUX
key to operate the second DVD Player as follows:
NOTE: AUX is preset at the factory to control an RCA VCR.
Performing the below steps will overwrite those settings.
1. On the remote control,press AUX once; it will
blink once.Then press and hold SETUP until
the AUX key blinks twice,then release SETUP.
2. Enter 9 - 9 - 2.The AUX key will blink twice.
3. Press DVD once,then press AUX once. The
AUX key will blink twice.
4. The AUX key is now ready to be programmed
for your second DVD player.See Programming
Device Control on page 10.
To re-assign other device keys,repeat steps 1 to 4 and
substitute the key sequence using the following chart:
NOTE:Only one device can be assigned to an unused device key
at a time.
To Re-Assign Perform Key Sequence
AUX as 2nd AUD key: AUX- SETUP - 9 - 9 - 2 - AUD - AUX
AUX as 2nd TV key: AUX- SETUP - 9 - 9 - 2- TV - AUX
AUX as 2nd CBL key: AUX- SETUP - 9 - 9 - 2- CBL - AUX
AUX back to AUX: AUX- SETUP- 9 - 9 - 2 - AUX - AUX
To re-assign another unused device key,substitute it for
the AUX key above and then perform the sequence.For
example,to re-assign an unused AUD key as a second DVD
key, perform AUD - SETUP - 9- 9- 2- DVD - AUD.
When a re-assignment is done,the selected device key
(e.g.,AUD) will blink twice to confirm your choice.At that
time,you will need to program device control (see
Programming Device Control on page 10).
Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 30