Filter
Top Products
10
5. Repeat step 4 (on the previous page) three more times for
remaining digits.Use
2 for the second digit,3 for the third
digit,and
4 for the fourth digit.Write down the code dig-
its in the remaining TV code boxes on page 8.
6. To check for codes of other devices,repeat steps 1
through 5 (starting on the previous page),but substitute
the appropriate device key for each device you are check-
ing.Write down the device’s code digits in the appropriate
code boxes on page 8.
PROGRAMMING A MASTER POWER MACRO
In its default state,the POWER key on the One For All 3 Device Universal
Remote Control will individually power your home entertainment devices
on or off.However,you can also program a
Master Power Macro onto the
POWER key that will sequentially turn on or off all the devices with a single
key press.
Programming The Power Key For The Master Power Macro
1. Press and hold SET until the LED (red light) blinks twice,
then release SET.
2. Enter
9 - 9 - 5.The LED will blink twice.Then press POWER
once.
3. For the first device you want in the power-on sequence,
press its device key (e.g.,
CBL/SAT) once.
4. Repeat step 3 up to two more times to add desired
devices to the power-on sequence (e.g.,
DVD/VCR and TV).
5. To save the settings and exit the program,press and hold
SET until the LED blinks twice,then release SET.
Operating The Master Power Macro
1. After programming,point the remote control at the
devices and press POWER for at least 2 seconds to sequen-
tially turn on (or off) your devices.
NOTE: When POWER is pressed for less than 2 seconds, a power com-
mand will only be sent to the currently-selected device.This allows
you to still individually power devices on or off.
2. Devices will turn on (or off) according to your pro-
grammed sequence.
NOTE: The currently-selected device will always turn on or off first,
followed by the remaining programmed sequence.After the master
power sequence has been completed,the remote control will be set to
control the first powered-on device.
NOTE: If one or more devices does not have a POWER key, the power
off/on sequence may be slightly delayed when the remote control signals
the device(s).This action is normal.
continued on next page...
CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 10