Filter
Top Products
Setting up your devices
Example: to set up the TOTAL CONTROL for your Television:
1 Find your device code in the code section (page 12 – 21).
Codes are listed by brand name. The most popular
code is listed first. Make sure your television is switched on
(not on standby).
2 Press and release the TV key on your TOTAL CONTROL.
3 Press and hold down the SET key until the red light blinks
twice (the red light will blink once and then twice).
4 Enter your four-digit code using the number keys.
The red light will blink twice.
5 Now, aim your TOTAL CONTROL at your television and
press POWER. If your television switches off, your TOTAL
CONTROL should be ready to control your television.
- If your device does not respond, follow steps 1 through 5 with each
code listed for your brand. If none of the codes listed for your brand
operate your device, then try the Search Method described on page 7,
even if your brand is not listed at all.
- Some codes are quite similar. If your device does not respond or is not
functioning properly with one of the codes, try another code listed
under your brand.
- If the original remote control from your Video Recorder did not have a
Power key, press PLAY instead of POWER during step 5.
- To set up your other devices, follow the same instructions above, only
press the appropriate device key during step 2.
- Write your code in the boxes provided in the battery compartment
and on page 8, for quick, easy reference.
Devices can be found under the following keys:
- To set up a second TV, VCR or DVD see page 9.
6
TV
SET
P
____
POWER
Television
Video Recorder
DVD player
SET
MENU
TV
VCR
DVD
POWER