Filter
Top Products
www.urcsupport.com
10
1. Turn on your TV.
4. Enter one of the following four digits:
8. To search for the codes of your other devices,
repeat steps 1 through 6, but substitute the
appropriate key (e.g., AUX, DVD, AUD, or STB)
for the device you are searching for.
2. On the remote control, press TV once; it blinks
once. Then press and hold SETUP until the TV
key blinks twice.
3. Enter 9 9 1. The TV key blinks twice.
COMPONENT TYPE COMPONENT ID #
Set-Top Boxes (Cable, Sat, etc.)
0
TV 1
DVD/VCR/DVR 2
Audio Devices 3
5. Aim the remote control at the TV and press
POWER once.
6. Press and release the CH+ key continuously,
then stop when the TV turns off.
NOTE: In the search mode, the remote control sends
IR codes from its library to the selected
device, starting with the most popular code
first.
7. Press POWER. The TV should turn on, then
press SETUP to lock in the code.
NOTE: If the TV does not turn on during step 6, then
slowly press and release CH- to go back
through the codes. Press SETUP when the TV
turns on.
SETUP
Titan OCAP Remote Control.fm Page 10 Tuesday, May 27, 2008 1:55 PM