Filter
Top Products
Page 22
IMPORTANT: You have 30 seconds to per-
form the next step while you are in programming
mode. If you do not press a button within 30 sec-
onds, the component LED light will turn off. The
remote will exit the programming mode and you
will have to start over.
STEP 2: Press the component button you
want to turn on and then the POWER [ON]
button; repeat for all other components in the
order you want them to turn on. The compo-
nent LED lights will blink once each time you
press the POWER [ON] button.
STEP 3: Once you’ve entered all the
Power On commands, press the CHANNEL
Up [
CH
] button to save your MacroPower
commands. The component LED lights will
blink three times to confirm that the program-
ming has been successfully saved.
SUGGESTION: Most of the components
have the same signal to turn the power On and
Off. You may want to program MacroPower
only in the POWER [ON] button and save the
[SYSTEM OFF] button to turn components On
or Off individually.
Note: If you want to program MacroPower
for the [SYSTEM OFF] button, repeat the same
steps used for POWER [ON] programming.
COMPONENT
BUTTONS
CHANNEL
UP
POWER