Venturer KLV39120 Flat Panel Television User Manual


 
- 6 -
ACCESSORIES
Please Check and Identify the Included Accessories.
Remote control ............................................................................................................................. x 1
AAA 1.5V battery .......................................................................................................................... x 2
Mounting template ......................................................................................................................... x 1
1.06" (27mm) spacers .................................................................................................................. x 4
.57" (14.4mm) spacers ................................................................................................................. x 4
.32" (8.2mm) spacers ................................................................................................................... x 4
#M 5 x 69 mm screws .................................................................................................................... x 4
#M 5 x 40 mm screws ................................................................................................................... x 4
FM wire antenna ........................................................................................................................... x 1
AM LOOP antenna ........................................................................................................................ x 1
Battery Replacement
When the batteries become weak, the operating distance of the remote control is greatly reduced and you will
need to replace them.
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Notes:
Do not place the remote control near magnetic devices or magnetic cards.
If the remote control is not going to be used for a long time, remove the batteries to avoid corrosion
damage caused by battery leakage.
Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
Always remove batteries as soon as they become weak.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Weak batteries can leak and severely damage the remote control.
WARNING: Do not dispose of batteries in a fire. Batteries may explode or leak.
To Install Batteries
1. Open the battery door. 2. Insert two AAA batteries.
REMOTE CONTROL
Using the Remote Control
This remote control is magnetic and can be attached to most refrigerators. Some refrigerators panels
are not metallic. In this case, try attaching the magnetic remote control to the side of the refrigerator.
Point the remote control at the REMOTE SENSOR located on the unit.
When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may
be degraded, causing unreliable operation.
The recommended effective distance for remote operation is about 16 feet (5 meters).
CAUTION: When discarding batteries, environmental problems must be considered and local rules or laws
governing the disposal of these batteries must be strictly followed.