Filter
Top Products
E - 3
QUICK INSTALLATION
ATTACHING THE BASE STAND
• Before attaching (or detaching) the stand, unplug the AC cord from the AC input terminal.
Note: To detach the base stand, perform the
steps in reverse order.
CAUTIONS:
• Attach the base stand in the correct direction.
• Incorrect installation of the stand may result
in the unit falling over.
• Be sure to follow the instructions.
1. Confirm 4 screws (silver screws x2 & black
screws x2) are supplied with the unit.
2. Lay the unit down on a flat surface, so the
backside is facing up, making sure to place
a soft cushioned material (such as a pillow
or thick piece of foam) beneath the screen.
3. Attach the BASE STAND to the opening on
the rear of the unit.
4. Insert and tighten the four screws (supplied)
into the holes as shown below.
WARNING: The LCD display is very fragile and
must be protected at all times when attaching
the base stand. Be sure that nothing hard or
sharp, or anything that could scratch or damage
the LCD display, comes in contact with it. Do
NOT place pressure on the front of the unit at
any time because the screen could crack.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 3 15/16” x 3 15/
16” (100mm x 100mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit
according to the directions included with the mounting kit.
Four
mounting
holes
3 15/16”
3 15/16”
The Base Stand
Soft cushion
Silver
screws
(x2)
Black
screw
(x1)
Black
screw
(x1)
PLV16198S2_01-11.pmd 9/7/2007, 12:30 PM3