Venturer PLV36199S1 Flat Panel Television User Manual


 
E - 16
TV SETUP
Antenna : Air (over-the-air broadcasts, Ch 2-69) or CATV (cable/satellite broadcasts, CH 1-135)
mode are available.
Auto Scan : Search for usable stations and store them in memory.
Auto Scan Add CH : Search for more usable stations and add them in memory. The stations stored before
are still kept.
Channel Skip : Skip weak channels and the channels you don’t like.
Channel No. : Select a different TV channel.
Channel Label : Display and edit the channel label.
DTV Signal : Display the signal strength (for digital TV channels only).
TV MENU (For TV Mode Only)
1. Press the MENU button.
2. Use the or button to select TV, then press the
button to enter the TV settings.
3. Use the or button to select the options (Antenna,
Auto Scan, Auto Scan Add CH, Channel Skip,
Channel No. Channel Label or DTV Signal). Adjust
them using the or button, or press the button
to go into the detailed settings.
4. Press the MENU button to return to the previous
menu.
5. Repeat steps 3 and 4 to adjust other options.
6. To exit the MAIN MENU and return to the normal
screen, press the EXIT or MENU button repeatedly.
Channel Skip
1. Use the or button to select a channel. (Press the
button to select the last channel of the page; press
again to go to the next page. Press the button to
select the rst channel of the page; press again to
return to the previous page.)
2. Press the ENTER button to shift between On / Off.
(Select On to skip the selected channel. The channel
will not appear when you press the CH / CH
button.)
PICTURE AUDIOTIME SETUP PARENTAL TV
Antenna
AutoScan
AutoScan AddCH
ChannelSkip
ChannelNo.
ChannelLabel
DTVSignal
Air
5-5
XXX
UP/DOWN ADJUST
"MENU":EXIT
Good
PICTURE AUDIOTIME SETUP PARENTAL TV
"MENU":EXIT"ENTER":SELECT
Skip
On
On
Off
Off
Off
On
Off
No.
3
2
4
5
5-1
6
7
ProgramName
XXXX
XXX
XX
XX
XXXX
XXXXX
XXXX
NEXT
PICTURE AUDIOTIME SETUP PARENT AL T V
EDIT SELECT
"MENU":EXIT
X
Channel Label
You can edit a label for each channel.
1. Use the or button to select the number or letter.
Use the or button to move and edit the next
character.
2. After editing, the Channel and Channel Label will be
shown on the screen when you press the DISPLAY
button.
PLV36199.indd 16 8/28/2007 3:16:05 PM