Filter
Top Products
E - 4
QUICK INSTALLATION
When you turn on your television set for the
first time, be sure to place it on a solid stable
surface. To avoid danger, do not expose the
TV to water, or a heat source (e.g. lamp,
candle, radiator). Do not obstruct the
ventilation grid at the rear and be sure to
leave sufficient gaps around the unit as
shown.
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter Setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
1. Press the / button to select Yes. Press the
ENTER button to proceed with the initial setup.
2. Use the / button to select Antenna, then
press the / button to select Air or CATV.
3. Use the / button to select Auto Scan, then press the button to enter auto scan menu. Use the
/ button to select Start to Scan, and press the button to begin scanning (If you selected CATV
on Step 2, you need to select Cable System before Start to Scan). The system will automatically start
to scan and preset all available TV channels.
4. After scanning has finished, the system will return to the first TV channel scanned.
Make sure the RF aerial has been
connected properly to the
TV ANTENNA input jack on the rear
of the system.
:SELECT
Proceed with auto scan ?
No
Yes
"ENTER":COMFIRM
PICTURE AUDIO TIME SET UP PARENTAL
TV
TV
Antenna
Auto Scan
Auto Scan AddCH
Channel Skip
Channel No.
Channel Label
DTV Signal
CATV
UP/DOWN ADJUST
"MENU":EXIT
PICTURE AUDIO TIME SET UP PARENTAL
TV
TV
Cable System
Start to Scan
AUTO
UP/DOWN ADJUST
"MENU":EXIT
PICTURE AUDIO TIME SET UP PARENTAL
TV
TV
RF CH
Found
16
0
:
:
PRESS <MENU>TO EXIT AUTO SCAN