Filter
Top Products
Maintenance and Troubleshooting
52 Vidikron VL-40 and VL-46 Owner’s Operating Manual
PRE
L
IMINAR
Y
Picture is okay, but there is no
sound.
• Audio output is muted.
• Volume setting is too low.
• Source component is
connected incorrectly or
not at all.
• Speakers are connected
incorrectly or not at all.
• Audio settings are
incorrect.
• Press the MUTE button on
the remote control.
• Turn up the volume.
• Check audio connections to
source component.
• Check speaker connections
(Figure 3-8).
• Check the following
settings:
Digital Audio Out
(page 36), TV Speaker
(page 36) and HDMI Audio
(page 41).
Image is too bright and/or
lacks definition in the bright
areas of the image.
• Contrast is set too high. • Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright.
• Brightness is set too high. • Lower the brightness
setting.
Black or white dots appear on
all channels or a specific
channel.
• Antenna or cable TV source
is connected incorrectly or
not at all.
• Broadcast signal is weak.
• Check the antenna or cable
TV connection.
• If using an off-air antenna,
adjust its position or
location.
Colors in the image are
swapped; for example, reds
appear blue or vice versa.
• The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to the
wrong inputs on the DView.
• Ensure that the source
outputs are connected to
the correct DView input.
RGB-HD images appear
“noisy.”
•Clock and Phase settings
need adjustment.
• Manually adjust Clock and
Phase settings, or perform
an Auto-Adjust (refer to
PC
Mode Adjust on page 38).
“Out of range” appears
on-screen.
•The resolution and
frequency of the video card
in the computer are not
compatible with the DView.
• Select a compatible
resolution and vertical
frequency (refer to
Computer Signal
Compatibility on page 63).
The image is too large or too
small.
• Image size needs adjusting. • Adjust the image size (refer
to
PC Mode Adjust on
page 38).
Poor broadcast sound quality. • The sound quality of a
stereo broadcast may be
unstable in an area with a
weak signal.
•Use the MTS/SAP button
on the remote control to
select mono.
Table 5-1. Troubleshooting Chart (continued)
Symptom Possible Cause(s) Solution