Vidikron VP-4200a Flat Panel Television User Manual


 
Vidikron PlasmaView Owner’s Operating Manual 27
PRE
L
IMINAR
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Attach the two included ferrite cores to each end of the AC power cable as shown in
Figure 4-1. Doing so will reduce radio frequency interference (RFI) emissions to a level
that conforms to FCC regulations. Use the supplied cable ties to secure the cores in
place.
Figure 4-1. Attaching the Ferrite Cores to the Power Cable
3. Plug the female end of the power cord into
the AC receptacle on the rear of the
PlasmaView (AC 100V ~ 240V). Connect the
other end to your AC power source.
4. Set the main power switch at the rear of the
PlasmaView (see
Figure 2-4) to the “on”
position. Its power indicator lights red.
5. Press the POWER button on the underside
of the PlasmaView (see
Figure 2-1) or the
remote control (see Figure 2-5). The power
indicator lights solid green.
6. After a brief warm-up period (approximately 10 seconds), the PlasmaView will display an
image.
4.2
Changing the OSD
Language
The PlasmaView OSD language is initially set to English, but can also display the menus in
German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the
OSD language:
1. Press MENU.
2. Press repeatedly to select Option from the Main Menu.
3. Press SET to select Language.
4. Press the right- or left-arrow button ( or ) to highlight the desired language and
press SET. The change takes effect immediately.
4Operation
Ferrite core
Cable tie
AC power cord
T
o power outlet
As close as possible
To AC IN