Filter
Top Products
Operation
44 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
To clear a screen maintenance program, move the cursor to the DATE field and press CLEAR
on the remote control, using a straightened paper clip or similar object.
Select Return to exit the Program Timer menu.
Test Pattern: Select Test Pattern from the Option menu to display an inverse of the normal
picture on-screen, or a single color. Use this feature to repair burned-in areas of the display.
Press SET repeatedly to select INVERSE or a single color to display. Then, press MENU. To
select a different pattern or return to the normal picture, press the Installer Adjust menu
button, select Option, then select Test Pattern. Press SET repeatedly to select OFF or another
pattern.
Sidebar Adjust: Select Sidebar Adjust from the Option menu to adjust the color of the sides
of the screen when the Aspect Ratio is set to Standard 4:3 or 14:9 (refer to Table 4-1). The
range is from 0 to +255 for each color component (red, green and blue); the default setting is
+80 (gray).
When the 4:3 or 14:9 aspect ratio is selected, the PlasmaView can gradually shift the inactive
areas of the display in small increments every time it is turned on, to prevent burn-in at the
sides of the panel. To enable this feature, select
Auto Side Mask from the Sidebar Adjust
menu and set it to ON.
Select Return to exit the Sidebar Adjust menu.
Baud Rate: The default Baud Rate setting is 9600BPS. Do not change it unless specifically
instructed to do so by Vidikron Technical Support.
ID Number: The ID Number uniquely identifies the PlasmaView in multiple-panel or
video-wall installations. It is used to address serial commands to a specific panel when two or
more are daisy-chained together via the COMBINATION IN/OUT connectors (see
Figure 2-4).
For installations with only one PlasmaView, leave the ID Number set to 01. Do not change it
unless specifically instructed to do so by Vidikron Technical Support.
Fan Speed: Select Fan Speed from the Option Menu to control the operation of the
PlasmaView’s cooling fan.
In most cases, the default Fan Speed (AUTO) will maintain the correct operating temperature.
If the PlasmaView frequently turns off due to overheating, or in certain high-altitude
operating environments, you may need to change this setting to MAX.
OSD: Select OSD from the Option menu to set options relating to OSD menu appearance and
behavior.
• Display: When you select an aspect ratio or input with the remote control, the
PlasmaView displays your selection on-screen. When you adjust the volume or press
MUTE on the remote control, a slidebar appears as a visual indicator of the level.
To prevent the display of these items, select Display from the OSD menu and set it to OFF.
• Size: Select Size from the OSD menu to change the OSD menu size (SMALL or LARGE).
Select Return to exit the OSD menu.
INPUT 3
INSTALLER ADJ.
SCREEN
SET-UP
OPTION
PICTURE
ENTERSET
EXIT
MENU
: AUTO
: ON
: ISF CCC
: NORMAL
FAN SPEED
OSD
FRONT L.E.D.
ISF SETTINGS
VIDIKRON PRO
FRC