Vidikron VP-6500VHDa Flat Panel Television User Manual


 
Vidikron PlasmaView Owner’s Operating Manual 1
PRE
L
IMINAR
Y
1.1
About This Manual
This Owner’s Manual describes how to install, set up and operate the Vidikron PlasmaView
High-Definition Plasma Display (Model VP-6500VHD or VP-6500VHDa).
Throughout this manual, the Vidikron PlasmaView High-Definition Plasma Display is referred
to simply as the “PlasmaView.” Except where otherwise indicated, the information in this
manual applies to both PlasmaView models.
Target AudienceVidikron has prepared this manual to help home theater installers and end users get the
most out of the PlasmaView.
Vidikron has made every effort to ensure that this manual is accurate as of the date it was
printed. However, because of ongoing product improvements and customer feedback, it
may require updating from time to time. You can always find the latest version of this and
other Vidikron product manuals on-line, at www.Vidikron.com.
If You Have Comments About
This Manual...
Vidikron welcomes your comments about this manual. Send them to info@Vidikron.com.
Textual and Graphic
Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify the
information and instructions provided:
Remote control button identifiers are set in upper-case bold type; for example, “Press EXIT
to return to the previous menu.”
Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to 16:9,
type 16:9 <Enter>.”
All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following: <Enter>, <Spacebar>, <Control>, <Esc>
and <Tab>.
<Enter> indicates that you may press either the RETURN or ENTER key on your computer
keyboard if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used to
highlight important information, as in this example:
1Introduction
A carriage return must be used after each command or string.
Note