ViewEra V193 Flat Panel Television User Manual


 
2.2 Installation
The monitor is equipped with an automatic sensing AC power adapter for a voltage range from 100 to
240 VAC at a frequency of 50 to 60 Hz. Before connecting the cables, please make sure that the
monitor and the computer power are both turned off. Please follow the steps to install your monitor.
Before connecting cables to the V193 or V220 monitor, you need to remove the plastic cover on the
back of the monitor at first.
2.2.1 Connecting the signal cable
Plug one end of the VGA cable or DVI cable to the computer and the other end to the video signal
connector on the monitor, and then tighten the two screws on the cable connector.
2.2.2 Connecting power cord
Plug one end of the power cord into the input port of the monitor power supply and then insert the
other end into the socket of the electrical source.
2.2.3 Connecting the audio cable
Plug one end of the audio cable to audio jack on either computer or video device and the other end
to audio jack on the monitor.
4