Filter
Top Products
Page 8
Series 3 Cameras Installation Instructions
LENS SELECTION
Suitable lens types are C and CS mount in fixed iris, manual iris, auto iris or direct drive
versions. Sizes are shown below. Cameras are factory set for CS mount lenses. If using a
C mount lens, rotate either of the back focus screws approximately 30 turns anticlockwise
before fitting the lens.
LENS SETUP PROCEDURES
For manual or fixed iris lenses set the EI switch to ON.
Auto Iris lenses
Switch the EI off. Refer to the lens instructions and adjust the lens for the optimum picture
(video output level of 1V peak-to-peak).
Direct Drive lenses
Switch the EI off. Use an appropriate screwdriver to turn the lens level potentiometer (under
the hinged flap) fully clockwise then back off until the optimum picture is obtained (video
output level of 1V peak-to-peak).
FOCUS ADJUSTMENT
The back focus adjustment screws are located on the top and side of the case and should
be adjusted using an appropriate screwdriver. If possible, always use the top screw to
adjust the back focus mechanism.
Turn the adjuster screw clockwise or anticlockwise to obtain focus. When the focus is
sharp, turn the back focus adjustment screw 2 or 3 turns anticlockwise. The picture will
lose sharpness. Turn the back focus screw clockwise until focus is once again obtained. If
you have turned the back focus screw clockwise past the point of best focus, repeat the
procedure. The last turn of the back focus adjustment screw must always be in a
clockwise direction. Do not over turn the back focus mechanism.
Fixed Lenses
Set the lens focus to infinity and view an image greater than two metres away. Focus the
image using the back focus screw. Set the lens focus as required.
Manual Iris Lenses
Open the iris fully and set the lens focus to infinity. View an image greater than two metres
away. Focus the image using the back focus screw. Set the lens focus and iris as required.