Filter
Top Products
VIZIO SV320XVT & SV370XVT User Manual
16
www.VIZIO.com
Input Source
Rotate the Jog Wheel Left or Right to select Input and press in on the button. Rotate the Jog
Wheel Left or Right to cycle through the input sources by the following sequence: TV, AV(S-
video or Composite), COMPONENT, RGB ,HDMI1 , HDMI2, HDMI3. Press in on the button
to confirm the channel selection.
Exit
Rotate the Jog Wheel Left or Right to select Exit. Press in on the button to exit the Quick
Menu.
Power Off
Rotate the Jog Wheel Left or Right to select Power Off and Press in to turn off the HDTV.
Note: When the Quick Menu is displayed and no selection is made within three seconds, the menu will
exit automatically.
Insertion of Batteries in the Remote Control
Insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the
batteries with the (+) and (-) symbols inside the battery compartment. Re-attach the battery cover.
Precautionary Tips for Inserting the Batteries:
! Only use the specified AAA batteries.
! Do not mix new and old batteries. This may result in cracking or
leakage that may pose a fire risk or lead to personal injury.
! Inserting the batteries incorrectly may also result in cracking or
leakage that may pose a fire risk or lead to personal injury.
! Dispose of the batteries in accordance with local laws and
regulations.
! Keep the batteries away from children and pets.
Remote Control Range
Point the remote control at the remote control sensor to transmit the commands.
Do not place any obstacles between the remote control and the receiver window.
The effective range of the remote control is approximately 30 feet (10 meters) from the front of the
receiver window, 30° to the left and right, 20° up and down.
VIZIO Remote Control Precautions
The remote control should be kept dry and away from heat sources. Avoid humidity.
If the TV responds erratically to the remote control or does not respond at all, check the batteries. If the
batteries are low or exhausted, replace them with fresh batteries.
When not using the remote control for a long period of time, remove the batteries.
Do not take the batteries apart, heat them, or throw them into a fire.
Do not subject the remote control to undue physical stress, such as striking or dropping it.
Do not attempt to clean the remote control with a volatile solvent. Wipe it with a clean, damp cloth.