VIZIO SV420M & SV470M User Manual
Version 3/9/2009 13
www.VIZIO.com
VIZIO Remote Control
GUIDE – This button displays program information.
POWER (
) – Press this button to turn the TV on from the Standby
mode. Press it again to return to the Standby mode.
TV – Press this button to select TV.
AV – Press this button to select AV1 and AV2 (either Composite or S-
Video) input.
COMP – Press this button to select the Component (YPbPr) input. By
pressing this button repeatedly you will be switching from Component
1 to Component 2 and vice versa.
HDMI – Press this button to select the HDMI input. By pressing it
repeatedly you will go through all HDMI inputs in sequence.
MENU (Enter)– Use this button for the On-Screen Display (OSD)
menu. When it is used within a menu selection, pressing this key will
help you to make the selection of the feature to be adjusted after it has
been highlighted.
!"# $ -These labeled buttons are used to navigate the OSD menu.
When navigating the OSD menu, the arrows control the direction up
and down or left and right. They will also be used as value settings
when the slide bar is shown on the screen and option settings to turn a
feature off or on.
MUTE – This button turns the sound on and off.
LAST – This button recalls the previously viewed channel. If the On-
Screen Display (OSD) menu is being used, this button will allow you to
get back to previous menu screen or out to your program when you
press it repeatedly.
VOL !/" – This button turn the volume up or down.
CH !/" – This button change the channels up or down.hen
PIP – Pressing this key will make the picture-in picture feature to be
activated. The screen will show the smallest screen size available
when the key is first pressed; pressing it again will display the POP
option.
SWAP – Press to swap between small and big screens when in PIP
mode.
FREEZE – Press to freeze the main screen display. Press this button again to continue playing.
NUMBER BUTTON PAD – Use these buttons to select a
channel or enter a password.
INPUT (Back) – This button allows the user to cycle through
the inputs. Repeatedly pressing of this button will step you
through the input sources in the following sequence: TV, AV1
(S-VIDEO), AV2, Component1, Component2, RGB, HDMI1,
HDMI2, HDMI3, and HDMI4. Once you have stepped through
the entire sequence, you will return to the beginning.
- (DASH) – When selecting a digital channel directly use this
button for the separation of main and sub-channels. For
example, channel 28-2 would be selected by the button
sequence 2 8 ENTER 2.