Filter
Top Products
8
INSTALL WORK
SURFACES
FOR THE PLATINUM SERIES II 2200
You will need...left work surface, right work surface, four
1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16
inch or adjustable wrench.
Insert the left work surface tabs in the slots to the left of
the cooking box. Figure 10 (a). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 10 (b).
Insert the right work surface tabs in the slots to the right
of the cooking box. Figure 10 (c). Slip washers on the
bolts and insert the bolts as shown. Tighten.
Figure 10 (d).
Platinum Series II 2200
Figure 10
(a)
(b)
(c)
(d)
View from
left side
View from left
underside
View from
right side
View from right
underside
You will need... left work surface, side burner assembly,
four 1/4-20 x 1/2 inch bolts, four nylon washers and a
7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots to the left of
the cooking box. Figure 11 (a). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 11 (b).
Note: Remove protective covers from tabs of
side burner.
Insert the side burner assembly tabs in the slots to the
right of the cooking box. Figure 11 (c). Slip washers on
the bolts and insert the bolts as shown. Tighten.
Figure 11 (d).
Side burner can only be installed on right side
of barbecue.
Platinum Series II 3200
Figure 11
View from
left side
View from left
underside
View from
right side
View from right
underside
Tabs
Tabs
(d)
(b)
(c)
(a)
INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3200
After this assembly, proceed to step “Install Bottom
Rack” on page 12.