Filter
Top Products
11
Route the side burner hose so it will not interfere with the
scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 17. Figure 18 shows the quick
disconnect engaged.
Check that the side burner is properly assembled.
Manifold side view
Manifold side view
Figure 17
Figure 18
Male fitting
Quick disconnect
engaged
Side burner
hose
(c)
(a)
(b)
Figure 20
INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3400
(CONTINUED)
View from right
underside
To NG
supply
To side burner
Figure 19
Windshield
Burner
cap
Burner
ring
Burner
head
Burner
orifice
Burner
base
Grate
Slots
Lugs
WARNING: Set the burner ring onto the burner head.
Rotate the burner ring until the four lugs on the burner
ring are seated in the four slots on the burner head.
Figure 20 (b).
Note: The burner head has a hole in it that fits over the
igniter electrode.
After this assembly, proceed to step “Install Bottom
Rack” on page 12.
Igniter
electrode