Filter
Top Products
9
Route the side burner hose around the tank panel so it
will not interfere with the scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 12. Figure 13 shows the quick
disconnect engaged.
Check that the side burner is properly assembled.
Manifold side view
Manifold side view
Figure 12
Figure 13
Male fitting
Quick disconnect
engaged
Side burner
hose
(c)
(a)
(b)
Figure 15
INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3200
(CONTINUED)
View from right
underside
To NG
supply
To side burner
WARNING: Set the burner ring onto the burner head
with the slots facing up. Rotate the burner ring until
the four lugs on the burner ring are seated in the four
slots on the burner head. Figure 15 (b).
Note: The burner head has a hole in it that fits over the
igniter electrode.
After this assembly, proceed to step “Install Bottom
Rack” on page 12.
Figure 14
Windshield
Burner
cap
Burner
ring
Burner
head
Burner
orifice
Burner
base
Grate
Slots
Lugs
Igniter
electrode