Filter
Top Products
3
English
WARNING:
This device must be operated with the original power supply.
CAUTION:
The power supply outlet should be located near the LCD TV and should be easily accessible.
Always use the appropriate AC cord that is certied for your specic country. Some examples are listed below:
USA..................UL Canada.............CSA
Japan ............... Electric Appliance Control Act
IMPORTANT NOTICES CONCERNING POWER CORD SELECTION
The specific power cord for this LCD TV is enclosed and has been selected according to the country of
destination. Use the enclosed power cord to prevent electric shock. Observe the following guidelines if it is
necessary to replace the original cord set, or if there is no cord set enclosed. The female receptacle of the cord
set must meet IEC-60320 requirements and should look like Figure A1 below:
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL-listed, and CSA-labeled.
For LCD TVs that are to be placed on a desk or table, type SVT or SJT cord sets may be used. For LCD TVs
that are to be placed directly on the oor, only SJT type cord sets may be used. The cord set must be selected
according to the current rating for the LCD TV. Consult the table below for the selection criteria of power cords
used in the United States and Canada.
FCC COMPLIANCE STATEMENT
This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and
may cause harmful interference to radio communications if not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the LCD TV and the receiver.
•
Connect the LCD TV to an outlet on a circuit separate from to which the receiver is connected.
•
If the interference persists even after performing the above measures, consult the Westinghouse Service
Center or an experienced radio/TV technician for assistance.
FCC Warning
To assure continued FCC compliance, use a grounded power supply cord and the provided shielded
video interface cable with bonded ferrite cores. If a BNC cable is used, use only a shielded BNC (5)
cable. Also, any unauthorized changes or modications not expressly approved by manufacturer will
void the user's authority to operate this device.
Cord Type Size of Conductors in Cord
Maximum Current Rating of Unit
SJT
18 AWG
16 AWG
14 AWG
10 Amps
12 Amps
12 Amps
SVT
18 AWG
17 AWG
10 Amps
12 Amps
2. SAFETY GUIDELINES
IMPORTANT INFORMATION