Filter
Top Products
1
2
3
4
5
!
!
!
!
!
!
!
1
!
!
Specifications
Compatible with DISH programming
and DISH Solo HD receivers
Supports up to two receivers
For stationary use only
Includes 25 ft coaxial cable
Unit weight: 16 lbs
Stowed height: 15 in
Max. height deployed: 20.75 in
Diameter: 21 in
Reflector size: 18 in
Elevation range: 15–65°
UV-protected plastic reflector cover
Gray plastic base
Made in USA
Reflector cover
Protects inner components
from environment
Handle
Enables easy carrying of antenna
Eyelet
Enables securing of antenna to site
Secondary port
Connects to secondary receiver
Main port
Connects to primary receiver
Quick Setup for One Receiver
Make sure the Pathway X2 antenna is in a location with a clear view of the southern sky.
Align the Pathway X2 antenna so that cable connections are facing approximately North.
Connect the primary receiver to the “MAIN” port on the base.
After connecting the receiver to a power source, complete receiver setup. Select the number of receivers, eastern or western arc,
and the state that you are currently in. Then, press “Scan” to start scanning for satellites.
Watch TV!
Compatible
Receivers
The Pathway X2 antenna must be used
with DISH Solo HD receivers. Examples
of DISH Solo HD receivers include DISH
211z, 211k, 211, and 411 receivers.
Compatible Satellites
The Pathway X2 antenna can receive programming from DISH eastern or western arcs.
DISH Eastern Arc
Satellites 61.5°, 72°, 77°
DISH eastern arc will work in most
areas of the country but may not
be available in the Northwest. If
unavailable, use the western arc.
DISH Western Arc
Satellites 110°, 119°, 129°
DISH western arc will work in most areas
of the country; if unavailable, use the
eastern arc. Western arc may be required
for initial setup and software download.
Antenna Feet
The Pathway X2 antenna has four feet
on the bottom of the unit. Each foot has
two mounting spots on the underside
of the antenna. The antenna will come
with the feet in the inside holes. If
mounting the antenna on Winegard
Model TR-1518 tripod, mount the feet
in the inside holes. For extra support
when not using the TR-1518, mount the
feet in the outside holes.
Warnings
Do not use excessive force when
manually rotating the antenna, as
this could cause damage to motors
and gears.
The antenna is not intended for
permanent mounting on any vehicle.
Do not place the unit in water >2 in. deep,
or water may damage the electronics.
Do not install or operate the antenna
in winds of 35 mph or greater. The
antenna will roll in winds ≥35 mph.
Do not insert your fingers around the
base while the antenna is moving.
Care should be taken when transporting
and setting up the antenna. Do not toss
or drop the antenna.
Do not paint the antenna. Painting the
antenna may cause signal degradation
and will void your warranty.
The antenna is not meant for use with
the Carryout
®
ladder mount. Installing
the antenna on the Carryout ladder
mount may lead to serious injury and/
or equipment and property damage.
A 25 foot coaxial cable is included
and recommended for use with
the antenna. Longer coax runs
could potentially cause intermittent
problems. Maximum cable length
should never exceed 50 feet.