Filter
Top Products
7
Adding the Low Band VHF Add-On Kit
For RF Channels 2–6 and/or FM
Locate the hole in the bottom of the boom near the mast clamp.
Insert the large screw through the hole in the bottom of the boom
(Figure 11). Place the element extension with crimped ends onto the
screw. Then, install the clip onto the element extension with crimped
ends so that the holes in both parts align. Thread a small flange nut on
the screw, and tighten.
Figure 10
Figure 11
Mast Clamp
Element Extension
with Crimped Ends
Hole
Mast Clamp
Large Screw
If unsure whether or not to install the Low Band VHF Add-On Kit, see
the section “Do I Need to Install the Low Band VHF Kit?” on page 3.