Filter
Top Products
5
6. On each foot, screw the flange nut to the base of
the leveling screw on the mounting foot, flange up.
Place rubber washer, with the rubber side up, on
the nut, Figure 2. Push mounting foot under base.
Push foot screw through the base and tighten lock
nut to secure foot to base. Be sure the base feet are
pointing away from the base. Base feet will be re-
moved later during install.
!
Installation
Install in DRY conditions only!
If you have trouble seeing the numbers,
try using a magnifying glass!
FIGURE 2
FIGURE 3
OBSTRUCTION
UNIT BASE
Installing unit on roof of vehicle —
5. Determine which programming you will be using.
This will determine how you set your switches.
For DISH Network
TM
set
switches to 119°.
For DIRECTV
®
set switches to 101°.
For ExpressVu
TM
set switches 092°.
LEVELING SCREW
RUBBER WASHER
FLANGE NUT
(FLANGE UP)
Obstruction Ht. Unit Clearance
8” .......................................... 4”
10” ................................... 11.5”
12” ...................................... 19”
15” ...................................... 32”
IMPORTANT! Do not install this system
in the rain, or under any wet conditions. Moisture
may affect electronics and void your warranty!
1. For best performance and to reduce signal acquisi-
tion time, park vehicle on a level surface.
2. Select a level spot on your roof for installation.
• The unit should be no more than +/-1° off level.
• Be sure no roof-mounted equipment is
blocking the satellite “line of sight.”
• You will need to decide where the wires will enter
the vehicle. A coax and an 18 gauge power wire
will need to be placed in the vehicle. The power
wire will go to the nearest +12 VDC power source;
the coax will be routed through the demulitplexer to
your satellite receiver. These wires should be hidden.
3. Remove screws holding dome to base and remove
dome. Place dome in safe spot to avoid damage. Place
base on vehicle roof in the location selected.
4. Remove wire ties used for shipping. There are
three; one on each side of the reflector and one at the
the rear of the reflector holding down the counter-
weight. See Figure 1, page 4.
MOUNTING
FOOT
7. After selecting location for unit (see step 2),
put the unit on the centerline of the coach.
REAR MOUNTING FOOT MUST FACE
DIRECTLY OFF REAR OF VEHICLE,
Figure 1. There is a 30 foot power cord and 30
foot coax cable going through the Heyco
®
con-
nectors on the base.
Placing the rear base bracket on the centerline,
facing the rear of the vehicle, will center the unit.
8. Using the chart,
determine the
minimum distances to
other equipment.
Measure these
distances as
demonstrated in Figure 3.