Filter
Top Products
6
1. Open box and remove packing material.
2. Lift unit out of box vertically. Do not turn box and
“roll” out, or turn upside down to remove.
1 large yellow spade connector
2 small red spade connectors
All required screws and washers
1 base with electronics, dish, single LNBF
30’ power cable and 30’ coaxial cable
!
USE 2 PEOPLE
when removing the unit
from the carton.
Parts Included • Tools Needed • How to Unpack
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
PARTS INCLUDED:
1 Radome
1 Power switch
1 Wall plate (white)
1 Surface mount box
1 Cable entry plate
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
UNPACKING THE UNIT
Level
Drill w/3/4” bit
1-1/4” hole saw (if mounting switch in wall)
3/8” Box/Open end wrench for dome screws
7/16” Open end wrench
Phillips screw driver #2
Sealant (consult RV manufacturer for proper type
for your roof material)
!
Do not paint dome!
Painting dome will cause
signal degradation.
!
BE CAREFUL when
removing unit. Dome is
attached to base by
ONLY THREE PEICES
OF TAPE!