Filter
Top Products
13
8. Assemble dish and backup structure using bolts
and nuts provided, Figure 9.
9. Install cover using the following steps. Refer to Figure
10 for parts.
• Press nylon inserts (# 4) into square holes in bracket (# 5).
• Slide bracket onto unit. Dish must be in stowed position.
• Fasten bracket to turret using threading cutting screws (# 2).
NOTE: Figure 10A shows cover bracket installed on unit.
• Place cover (# 3) over bracket (# 5).
• Line up holes in cover to nylon inserts (# 4).
• Secure cover using screws (# 1).
FIGURE 9
FIGURE 10 FIGURE 10A
TEST UNIT TO BE SURE IT OPERATES PROPERLY BEFORE YOU APPLY ANY SEALANT!
Use a sealant compatible with your roof material.
7. Install the vent tube on the back of the mount base (This is
the side opposite the word FRONT). The hole for the vent
tube is shown in Figure 8. CAUTION: DO NOT seal hole in
vent tube. Put sealant around the outside of the vent tube,
approximately 1/2 inch from end. Push the vent tube into
the hole, Figure 8. The sealant will seal the hole as you
push in. Leave approximately 2 to 2-1/2 inches of the vent
tube extending from the hole. DO NOT APPLY SEALANT
TO ANY SURFACES UNTIL YOU TEST YOUR UNIT.
FIGURE 8
5. Cut the cable wrap approximately four (4) inches away from point where it enters the cable-entry plate,
Figure 7, 7A. This allows proper sealant coverage. Do not damage cables when cutting away the cable wrap.
(The cable wrap protects and keeps together in one unit the coaxial cable, electrical cable and 8 wire data
cable.) After cutting, wrap the outer cable wrap with electrical tape as shown, Figure 7, 7A. Push cable
through cable entry point on roof. Do not damage cable. DO NOT APPLY SEALANT AT THIS TIME.
6. Pre-drill 1/8” holes for cable entry plate. Fasten down with screws provided. DO NOT APPLY SEALANT.
FIGURE 7, RM-9946 FIGURE 7A, RM-9947
Cable wrap. Cut 4” away
before putting under cable-
entry plate.
Coax cable
8 wire data cable
Electrical cable
Cable wrap. Cut 4” away
before putting under
cable-entry plate.
Coax cable
8 wire data cable
Electrical cable
Electrical tape,
wrapped at cut
line.
Electrical tape,
wrapped at cut
line.
#1
Phillips
Head Screws
#2
Hex
Head
Screws
#3
Cover
#4
Nylon
Inserts
#5
Cover
Bracket
Vent tube hole
Vent tube
Sealant
1/2”