3
OPERATIONS DO’S AND DON’T’S
DO’S
1. Do check parking location for obstructions before
raising antenna.
2. Do carefully raise, lower and rotate the antenna — if
difficult, check for cause.
3. Do rotate slowly when searching for the satellite(s)
and check fine tuning on TV set for proper adjustment.
4. Do lower antenna before moving vehicle.
5. Activate programming by calling programming
provider for your receiver.
DON’T’S
1. Don’t move RV/Coach with the antenna in the UP
position. This will VOID your warranty. This may
also cause damage to your roof.
2. Don’t force the elevating crank up or down. Check for
the cause.
3. Don’t rotate directional handle hard against stops.
4. Don’t apply paint on top of base plate or anywhere
on the lift.
5. Don’t apply approved sealing compound on gear
housing.
FIGURE 1
FIGURE 2
SUGGESTED SETUPS
FOR MULTIPLE TVS