Filter
Top Products
You must change the numbered switches found
on the electronics box under the dome before
replacing the dome.
Change the switch settings to the settings for
your programming provider. Hybrid mode is
for use in areas where the 129° satellite is not
available and standard DISH
®
settings fail to
provide HD programming.
Once the switch settings are
appropriately set for your
programming provider, the
dome can be replaced.
1.
2.
3.
4.
Replace the dome.
Align the holes in the base with the holes in
the dome. If installing a handle, align the holes
in the handle with the holes in the base. To
protect the cable connections from accidental
damage, install the handle using the two holes
closest to the cable connections.
If replacing the dome on a roof-mounted
unit, make sure that the decals on the
dome face perpendicular to the main and
secondary ports. If replacing the dome on a
portable unit, make sure that the decal faces
opposite the main and secondary ports.
Thread a screw through each hole, and
tighten with a #2 Phillips screwdriver.
Do not overtighten!
Route the two coaxial cables underneath
“LNBF” and “RECEIVER” through cable
harness 1.
Route the cable running from “RECEIVER”
and the cable running from the right side of
the LNB through cable harness 2.
Route the first and second motor connection
cables through cable harness 3. Also, route
the power cable through this cable harness.
Route the first and second motor connection
cables and the power cable through cable
harness 4.
1.
2.
3.
4.
0 = Up
1 = Down
Key
DIRECTV
®
1 2 3 4 5 6 7 8
DISH
1 2 3 4 5 6 7 8
Bell TV™
1 2 3 4 5 6 7 8
DISH Hybrid
1 2 3 4 5 6 7 8
Winegard Company • 3000 Kirkwood Street • Burlington, IA
52601 1-800-288-8094 • Fax 319-754-0787 • www.winegard.com
Printed in U.S.A. ©2012 Winegard Company 7/12 2452280
Winegard is a registered trademark of Winegard Company.
DISH is a registered trademark of DISH Network L.L.C.
DIRECTV is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corp.
Bell TV is a registered trademark of Bell Canada, Inc.
Disclaimer: Although every effort has been made to ensure that the information
in this manual is correct and complete, no company shall be held liable for any
errors or omissions in this document. Information provided in this document was
accurate at time of printing.
Changing Switch Settings
Re-Installing the Dome
Routing Cables through
the Four Cable Harnesses