Filter
Top Products
Model RP-SK73 Shaw Direct Replacement LNB
1. Remove and set aside the four nuts and bolts holding the LNB guard
to the feed arm. Then, remove the LNB guard from the feed arm.
2. Remove and set aside the screw holding the LNB to the feed arm.
3. Disconnect the four coax cables from the
LNB using a
7
/
16
” wrench, and carefully
remove the LNB from the feed arm.
4. Connect the four cables running
through the feed arm to the four
ports on the replacement LNB. The
cables can be connected in any order.
Tighten each cable until fingertight,
and then use a
7
/
16
” wrench to tighten
a quarter turn more.
5. Slide the LNB into the feed arm, and re-install the screw (removed earlier)
through the underside of the feed arm and replacement LNB. Tighten.
6. Slide the LNB guard onto the feed arm and over the LNB. The front of
the LNB guard should be ~½″ in front of the LNB.
7. Install the four bolts through the four holes in the LNB guard. Thread a
nut onto each bolt, and tighten.
Stowing the Antenna
1. Plug in the interface box.
2. Press and hold “POWER” for two seconds to turn on the interface box.
Then, press the Power button again to stow the antenna.
Four coax cables
connected to LNB
Bolts holding LNB
guard to feed arm
Screw holding
LNB to feed arm
Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000
1-800/788-4417 • FAX 319/754-0787 • www.winegard.com
Printed in U.S.A. • ©2012 Winegard Company Rev1 4/13 2452261
Winegard and TRAV’LER are registered trademarks of Winegard Company.
DIRECTV is a registered trademark of DIRECTV, LLC. DISH is a registered trademark of DISH Network L.L.C.
Shaw Direct is a trademark of Shaw Satellite G.P.
Disclaimer: Although every effort has been made to ensure that the information in this manual is correct
and complete, no company shall be held liable for any errors or omissions in this manual. Information
provided in this manual was accurate at time of printing.