Filter
Top Products
CONNECTING COAX CABLE TO THE ANTENNA
1.Slide small antenna gasket (previously removed from
the middle of the large mount gasket) onto coax.
2.Slide coax cable (with connector installed) into cable
tool through the slot in the side of the tool, hex end up,
Figure 2.
3. Push the cable up until the end of the connector is
flush with the hex-shaped end of the cable tool. See
Figure 3.
4. Insert the cable tool with cable attached into the
mounting bracket on the underside of the antenna,
aligning the end of the connector with the cable
connection on the antenna. Push up until you feel a
SLIGHT resistance.
5. Turn cable tool to the right until the connector is
tight.
6. Remove cable tool.
INSTALLING ANTENNA ON MOUNT
1. After cable connection is made, slide antenna gasket
down coax to top of mount. Then slide antenna onto
mount. GENTLY pull back any extra cable inside ve-
hicle.
2. Fasten antenna to mount using 1/4-20 carriage bolts
(#6) and hex flange nuts (#5). Tighten firmly to prevent
antenna from turning on mount or mast.
COAXIAL
CABLE
ANTENNA
GASKET
CABLE
CONNECTOR
FLUSH WITH
END OF
CABLE TOOL
FIGURE 3
FIGURE 2
CABLE
TOOL
OPTION 1
1” DIAMETER MOUNT
& SCREWS (provided).
LARGE MOUNT
GASKET
INSTALL CABLE
GASKET PLUG
REMOVE SMALL
ANTENNA GASKET
OPTION 2
DO NOT USE
CABLE GASKET
PLUG
LARGE MOUNT
GASKET
1” DIAMETER MOUNT
& SCREWS (provided).
BEFORE INSTALLING ANTENNA MOUNT, CHOOSE
ONE OF THE FOLLOWING MOUNTING OPTIONS
THAT BEST SUITS YOUR INSTALLATION NEEDS.
Start by removing the small antenna gasket from the
center of the large mount gasket. Save it for later
use. See either of two Option figures in next column.
OPTION 1: Drill 5/8” hole through roof. Run cable
through roof up center of large mount gasket and an-
tenna mount. See Option 1. Install cable gasket plug in
base. Route cable from antenna to wall plate.
BEFORE YOU BEGIN:
Decide location of power supply before
mounting your antenna.
A wiring diagram, Figure 1, will help you determine the
location for your antenna and power supply. Antenna
and power supply location determines where and
how you run cables.
DO NOT begin installation before carefully reading
all installation instructions.
FIGURE 1
ANTENNA
ATTACHING MOUNT TO ROOF
Securely fasten antenna mount to roof making sure to place
large mount gasket between mount and roof, using the 4
sets of washers and lag screws supplied. Seal around
mount base and over screw heads with approved sealant
for your roof. Contact the manufacturer of your RV.
ANTENNA
1” DIAMETER MOUNT
& SCREWS (provided).
COAXIAL CABLE
SMALL ANTENNA
GASKET
LARGE MOUNT
GASKET
CABLE GASKET PLUG
ANTENNA MOUNTING
BRACKET
OPTION 2: Run cable supplied down through mount
base and out open slot in base of antenna mount. See
Option 2 figure below. Finish routing cable to wall plate.
The Parts:
REMOVE SMALL
ANTENNA GASKET
+12 VDC
Source
15’ COAX
CABLE
(SUPPLIED)*
TV
12 GA WIRE
(Not provided)
+ -
*IF A LONGER CABLE IS
NEEDED, USE A LENGTH
OF RG6/U COAX.
POWER
SUPPLY