Woods Equipment 1012 TV Mount User Manual


 
14 Hydraulic Installation
PN - 59744 (12/14/01)
#59732 Hose Kit Cont’d
Verification of Control Movements
1. Comply with all Safety Rules and start the tractor.
2. Mount loader to tractor by activating bucket cylin-
ders to raise or lower the loader side rails into the
front mount. Slowly advance tractor forward, activat-
ing appropriate cylinders to engage loader completely
into mounts.
3. Insert mounting pins and secure with klik pins.
4. Check that all hydraulic control lever positions
operate the loader movements correctly as shown in
Figure 12.
5. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect prop-
erly. Loader control movements must be correct
before proceeding.
6. Once all loader functions are correct, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic system.
7. When hose routings and correct loader opera-
tions are verified, identify each circuit by placing a
matching colored band around the male and female
quick-disconnect coupler set. The colored bands will
make re-installation easier when the loader is
removed from the tractor.
8. Be sure that adequate slack is left in the hoses so
they can move as the loader moves through its full
range of motion.
9. Attach plastic tie straps every 20” around the
hoses to keep them tightly bound and away from con-
tact with the ground or other moving parts on tractor.
10. Before operating the loader, make sure that the
Pre-Delivery and Pre-Operation Check list from the
operator section in the Loader Operator’s Manual
have been completed.
Figure 12 Single Lever Control Operation
Handle Forward - Boom down
Handle forward to limit - Float position
Handle back - Boom up
Handle to right - Dump bucket or attachment
Handle to left - Rollback bucket or attachment
221
)/2$7 326,7,21
52//%$&.
/,)7
/2:(5
'803
/(9(5
&21752/
75$&725
)5217