Filter
Top Products
Mount Installation 7
PN - 59744 (12/14//01)
LOADER MOUNT INSTALLATION Cont’d
Install Loader Mounts
1. Remove two cap screws and spacers securing
quick coupler bracket to right side of tractor housing
as shown in Figure 1.
Figure 1 Remove Hardware From Quick Coupler
Bracket
2. Attach right rear mount to tractor housing using
four cap screws (20), hardened flat washers (14), and
1/2 spacer washers (19).
3. Place quick coupler bracket between 1/2 inch
spacer washer and right rear mount as shown in Fig-
ure 2.
4. Install left rear mount to tractor housing using four
cap screws (20), hardened flat washers (14), and 1/2
spacer washers (19).
1. 59695 Right rear mount
14. 58337 5/8 Hardened flat washer
19. 58335 .656 x 1.50 x .5 Washer
20. 58334 M16 x 2.0P x 60mm Cap screw
Figure 2 Right Rear Mount and Quick Coupler
Bracket Installed
Remove Hardware
from Bracket
DP1
20
14
19
Quick Coupler Bracket
DP2
1