Filter
Top Products
Installation 5
MAN0549 (6/30/2006)
BACKHOE 3-POINT MOUNT INSTALLATION
TRACTOR PREPARATION
NOTE: For installing this 3-point mounting kit, refer-
ence to right, left, forward and rearward directions are
determined from the operator’s position in the back-
hoe seat.
NOTE: Leave all hardware loose until mounting kit
has been fit up.
1. Refer to the WOODS BH90-X Backhoe Opera-
tor’s Manual for backhoe assembly instructions.
2. Remove the tractor top link and top link storage
bracket, if equipped.
* Operator’s seat must be located in the lowest and
most forward position to obtain 40" minimum radius.
Figure 1. Seat Clearance
Attach Rear Brackets to Backhoe
1. Attach rear brackets (4 & 5) to main frame using
bolts (6), hardened flat washers (16), and hex
nuts (8) as shown in Figure 2.
2. Torque hardware to 297 lbs-ft.
4. 37682 Right mount bracket
5. 37683 Left mount bracket
6. 13759 3/4 NC x 2-1/4 HHCS GR5
8. 1450 3/4 NC Hex nut
16. 57798 3/4 Hardened flat washer
Figure 2. Rear Bracket Installation