Xantech 490-95 Universal Remote User Manual


 
INSTALLATION INSTRUCTIONS
MODEL 490-95
MICRO LINK™ “PLASMA FRIENDLY” INFRARED RECEIVER
TABLE OF CONTENTS
INTRODUCTION ............................................................................................................................................................. 1
Features ...................................................................................................................................................................... 1
Specifications .............................................................................................................................................................. 1
INSTALLATION ............................................................................................................................................................... 2
Placement ................................................................................................................................................................... 2
Mounting...................................................................................................................................................................... 2
Application Wiring........................................................................................................................................................ 3
Advanced Wiring Configuration.................................................................................................................................... 3
3.5mm Mini Plug Pinout ............................................................................................................................................... 4
INTRODUCTION
The 490-95 is designed to reject interference from Plasma Displays from entering the IR signal line. These Small IR
Receivers are intended to be mounted in panels, doors, cabinets, etc. for control of A/V equipment behind closed doors or
any IR Repeater System that is in close proximity of a Plasma or LCD Displays. Modeled after the original 490-90, the
490-95 offers the same features as its predecessor but in a smaller mounting frame.
FEATURES
Small size; mounts in ¾” diameter hole. 2¾ inches deep (70mm)
Quick-Connect 3.5mm Stereo Mini Plug on 7ft. (213.36cm) cable for direct plug-in to Xantech Connecting Blocks
Works in normal 3-wire mode (12VDC, IR, GND)
Green Talkback LED for System Verification
Improved Fluorescent Light rejection (under most conditions) and rejection from LCD Displays
Can be used in Direct Sunlight
RF Grid included for EMI interference reduction
Includes CB12 Connecting Block for easy connection and extension of 7' ribbon cable
7 units may be powered by one 781RG power supply
Note: The 490-95 will not operate in 2-wire Phantom Power mode
SPECIFICATIONS
Infrared modulation frequency bandwidth: 30 - 100 kHz
Reception range: up to 55 feet (17M), depending on local conditions
Reception angle: 55 degrees off axis for 50% range reduction
Cable requirements: 3-conductor. Use 24 gauge up to 200' (61M), 22 gauge up to 600' (182.5M), 20 gauge up to
1000' (305M), 18 gauge up to 2000' (610KM) -- unshielded OK)
Maximum transmission length: One mile using 18 gauge wire (1.6KM)
Maximum current output: 100 mA
Dimensions: 0.75" diameter x 2.75" deep (19mm x 70mm)
Power requirements: 12 volts DC @ 20 mA