Xantech CC62 Universal Remote User Manual


  Open as PDF
of 5
 
5
Remote Control Switchers
RELAY
1
RELAY
2
RELAY
3
RELAY
4
RELAY
5
RELAY
6
CC62
REMOTE RELAY MODULE
IR CONFIRM
12 VDC
1A
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
NO
NC
1
12VDC
12VDC
1234
BANK
RES DEL SEQ PGM
+
–
234567891011 141516OG
–+
12 13
ON
791-44
Amplified
Connecting
Block
1
2
34
56789
VGGS
VGGS
VGGS
VGGS
VGGS
VGGS
VGGS
VGGS
VGGS
3-conductor IR Control Leads
to IR receivers and Keypads
in Remote Rooms
(Home Runs)
CB18
Strip-IR
Parallel
Connecting
Block
(see text,
item 3)
CD Changer
Mouse
Emitters
CC62
Remote Relay Module
Satellite Receiver
VCR
Laser Disc
CONTROLLED COMPONENTS
To 120 V AC
(u
nswitch
ed)
782-00
Power
Supply
Wire size typically AWG 20-24
+12V DC
To 120 V AC
(unswitched)
786-00
Power Supply
(included)
IR Output
Model 590
(rear panel)
Ground or "–"
return wires.
2-conductor lead
carries +12V DC
power to the
791-44 and to the
IR receivers &
keypads connected
to the CB18.
+12 VDC
GND
EMITTERS
12 VDC
HIGH
IR
OUT
STATUS
IR IN
IR
RCVR
791-44
AMPLIFIED
CONNECTING BLOCK
282M
or
283M
AV Receiver
+12V
GND
GND
IR IN
Fig. 5 Using a CC62 to provide switch closures for a 590 Programmable Controller
CB18. If more are needed, you could "double-up" on each connector or use an additional CB18.
• • •
IMPORTANT
• • •
1. Power Supply Considerations. Because of the relatively high current required to drive the relays
in the CC62, the Xantech Model 782-00 High Current Regulated Power Supply
must
be used. In Fig.
4, all of the system IR control devices are also powered from the 782-00 through the CC62.
To be sure you have sufficient power supply capability in your particular system, calculate the total
current required using the method shown in the 791-44 instructions, then add 300 mA for the CC62.
If the total exceeds 1 Amp, use a second supply to power the IR devices separately through the 791-
44.
2. The devices to be switched are connected to the Model CC62 by the six-terminal plug-in connectors.
The actual relays used in a given system are not important (if all six are not used). For instance, devices
will work just as well connected to relays 5 and 6 as they would connected to relays 1 and 2.
3. The Model CC62 is intended to be mounted on a flat surface or onto a standard 19-inch rack.
CC62
2-6-01
Rev.C
 previous