Filter
Top Products
Installation
Xerox LS 3270
- 12 -
2.3. Testing
PCL driver:
The default configuration of the interface will suffice for
most application programs and uses. You should only
change the configuration shown in the test printout if you
have special requirements.
If you should wish to change the configuration, the options
may be set from the line as described in the Programmer's
Guide; document no. D62077 (see "Related Manuals").
FSL Driver
With the FSL driver you have selected an unprogrammed
printer driver. You have to program the internal setup of the
box to suit your printing requirements. See Programmer's
Guide; document no. D62077 for further details.
1. Power the unit ON.
2. Turn the rotary switch to the “T” position and back to the
original position. This will generate a settings printout.
3. When the switch has been turned back to its original position,
the CU indicator will start flashing for approximately 30
seconds.
4 Turn the rotary switch to the “T” position once again while the
CU indicator is flashing. The unit will now enter Online HEX
dump mode. The dump mode is terminated by turning the
switch away from and back into the “T” position.
NOTE:
The CU indicator will be blinking rapidly while the
rotary switch is in the “T” position. This is an
indication that the “T” position is not a valid
permanent position.
5. Compare the settings printout (FSL or PCL printout) with the
printout illustrated in C hapter 8, Test Printouts.