Filter
Top Products
36
■ CENTER SP (center speaker mode)
By adding a center speaker to your speaker configuration,
the unit can provide good dialog localization for many
listeners and superior synchronization of sound and images.
Choices: LRG (large), SML (small), NON (none)
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center channel
are directed to the speakers selected with “BASS OUT”.
NON
Select this if you do not have a center speaker. All of the
center channel signals are directed to the left and right main
speakers.
■ MAIN SP (main speaker mode)
Choices: LARGE, SMALL
Initial setting: LARGE
LARGE
Select this if you have large main speakers. The entire range
of the left and right main channel signal is directed to the
left and right main speakers.
SMALL
Select this if you have small main speakers. The low-
frequency signals (90 Hz and below) of the main channel
are directed to the speakers selected with “BASS OUT”.
Note
• When you select MAIN for “BASS OUT”, the low-frequency
signals (90 Hz and below) of the main channel are directed to the
main speakers even if you select SMALL for the main speaker
mode.
SET MENU
4 Press – or + repeatedly to change the setting
of the item.
5 Press PRG– (or PRG+)
repeatedly until the input
source name appears to
exit from the SET MENU.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more than
one week, the settings of the SET MENU you adjusted
will return to the factory settings. If so, adjust the items
again.
1 SPEAKER SET (speaker mode
settings)
Use this feature to select suitable output modes for your
speaker configuration.
Note
• When 6CH INPUT is selected as the input source, level
adjustments in items of “1 SPEAKER SET” are not affected
(except “MAIN LVL”).
0107V420RDS35-42_EN 2/12/1, 1:36 PM36