Filter
Top Products
16
Connecting the power cord
After completing all connections, connect the AC power cord to an AC
power outlet
Note: When the player is in the “STANDBY” mode, it is still consuming some power.
If you wish to disconnect your player completely from the power, press the POWER
button.
Caution: Only qualified service personnel should remove the cover
or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover.
2 Insert batteries as indicated inside the battery compartment.
3 Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video
signal of your TV. This setting only affects the television’s on-screen display
that shows the stop and setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the steps below.
1 Press the POWER button on the front panel of the DVD player to turn
off the DVD player.
2 Press and hold 9 and
^
/T on the front of the DVD player. While
holding 9 and
^
/T , press the POWER button.
3 After PAL or NTSC appears on the display panel of the DVD player,
release 9 and
^
/T at the same time. The PAL or NTSC that appears
on the display panel indicates the current setting.
4 To change the setting, press
^
/T within three seconds. The new
setting (PAL or NTSC) will appear on the display panel.
PREPARATION
+
-
+
-