Filter
Top Products
42
A
B
C
Disc handling and maintenance
Handling precautions
ÁHold the disc by the edges so the surface will not be soiled
with fingerprints. ())
Fingerprints, dirt and scratches can cause skipping and dis-
tortion.
ÁDo not write on the label side with a ball-point pen or other
writing utensils.
ÁDo not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.
ÁBe careful not to drop or bend the disc.
ÁDo not install more than 1 disc on the disc tray.
ÁDo not try to close the disc tray when the disc is not in-
stalled properly. (*)
ÁBe sure to store the disc in its exclusive case when not in
use.
If the surface is soiled +
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center
hole toward the outer edge.
(If you wipe the discs using a circular motion, circular scratch-
es are likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm en-
vironment, moisture may form on the disc
Wipe this moisture off with a soft, dry, lint-free cloth before
using the disc.
Improper disc storage
You can damage discs if you store them in the following
places:
ÁAreas exposed to direct sunlight
ÁHumid or dusty areas
ÁAreas directly exposed to a heat outlet or heating appliance
Discs which cannot be played with this player
For Continental Europe and United Kingdom models
ÁDVD with Region No. other than “2” or “ALL”
For Australia model
ÁDVD with Region No. other than “4” or “ALL”
For other models
ÁDVD with Region No. other than “3” or “ALL”
ÁDVD-ROM
ÁDVD-R/DVD-RAM
ÁCD-ROM
ÁCDV
ÁCD-G
ÁDo not try to play Photo CD or CD-R.
To prevent a malfunction of this unit
ÁDo not use any non standard shaped CD (heart etc.) avail-
able on the market, because it may damage the unit.
ÁDo not use a CD with tape, seals, or paste on it, because
damage to the unit may result.
Maintenance
ÁBe sure to switch the power to the standby mode and dis-
connect the AC mains lead before maintaining the unit.
ÁWipe this unit with a dry soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth
which has been dipped in a weak soap-and-water solution
and wrung out thoroughly, and then wipe again with a dry
cloth.
ÁNever use alcohol, benzine, thinner, cleaning fluid or other
chemicals. And do not use compressed air to remove dust.
Disc tray
Disc