Filter
Top Products
Part E:
Tuning in your Zv channel
Use your HDTV’s remote control to enter your Zv channel number, excluding the ".99" at the end,
then wait a few moments to see if the HDTV tunes in Zv.
If not, enter the Zv channel number with ".1" at the end instead of ".99" (on some remotes the
decimal point "." may be a dash "-"), wait a few moments.
If the HDTV still doesn't tune in Zv, enter the full Zv channel number including the ".99" at the end,
wait a few moments.
This process helps many HDTVs auto-scan for a new channel. If the above doesn't work for your
HDTV, you'll need to perform a full "channel scan" to add new channels to the HDTV. This can take
30-45 minutes. Consult your HDTV's owner's manual for help.
Important: when performing the channel scan, set your HDTV to scan cable channels, not
over-the-air channels.
9
Part D:
Connect your HDTV to coax cabling
Begin Part D when you have been instructed to do so by the Zv Installation Wizard
1. Check to see what’s attached to the antenna input on your HDTV.
2. If there’s a coaxial cable from the wall connected to the HDTV’s antenna input, your HDTV is con-
nected correctly and you can skip to Part E.
3. Otherwise, connect your HDTV as shown in the diagram below:
Follow this
Get Going Guide until
prompted to follow
steps on your HDTV.
© 2008, ZeeVee, Inc. All rights reserved.
Set-top box
New coaxial cables (supplied)
To antenna input on HDTV
New splitter (supplied)
Existing coaxlal cable
New A/V cables or HDMI
cable, if not previously
installed (not supplied)
Follow this
Get Going Guide until
prompted to follow
steps on your HDTV.
Zv_Guide_Mech8.qxd:zv data sheet copy.qxd 7/28/08 1:53 PM Page 11