Zenith 206-3923 CRT Television User Manual


 
14
CABLE CHART
The chart below is typical of many cable system channel allocations.
TV/CABLE selection
1
2
3
4
5
Press MENU/ENTER. The menu screen will appear.
Press
or
to select
(SETUP)
menu.
Press
or to select “TV/CABLE”.
Press
or
to select “TV” or
“CABLE”.
Press MENU/ENTER repeatedly until the menu screen is cleared.
Otherwise, press EXIT to return to the normal screen immediately.
NOTE:
It may take a few seconds for a digital
channel picture to appear on screen
after being selected.
Memorizing channels
TV
- VHF/UHF channels
CABLE
- CABLE TV channels
This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set
into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s
memory. To use this TV with an antenna, set the TV/CABLE menu option to the TV mode. When shipped from the
factory, this menu option is in the CABLE mode.
J33A0621B_EN.indb 14J33A0621B_EN.indb 14 1/31/08 5:31:10 PM1/31/08 5:31:10 PM