Filter
Top Products
PAGE 33
Scan mode Characteristics
0 Channel up/down keys change channels only.
1 Channel down below the lowest channel (or
channel up higher than the highest) and TV
turns off.
14-I. STRT CH IN SM
When set to 1, installs TV on/off event below the start channel at
TV turn on.
15-I. SLEEP TIMER
When set to 1, the Sleep Timer feature may be used (but no mes-
sage is displayed prior to turn-off). When set to 0, the Sleep
Timer is not available.
16-I. EN. TIMER
Set to 1, Timer functions are available to user. Set to 0 to disable
Timer functions. (Clock must be set in order to use Timers.)
17-I. ALARM
Gives you the option of making the alarm function available to
the user. Set to 1, Alarm function is available to user. Set to 0 to
disable the Alarm function.
Note: Clock must be set in order to set the Alarm.
18-I. NOT USED
19-I. NOT USED
20-I. FEATURE LEVEL
Default set to ZEN 1 for Zenith IR remote control operation. Set O,
P LBL for Zenith Private Label IR remote control operation.
Warning: Do not set to “0” or remote will not control TV.
Note: Installer should leave Item 20-I set to 1.
21-I. V-CHIP
Set to 1 to activate V-Chip (Parental Control); have it available to
user to filter or control or restrict programming content. Set to 0
to turn V-Chip feature off, not available to user; no programming
restrictions can be set.
22-I. MAX BLK HRS
Set to 0 to 99 for the maximum V-Chip (Parental Control) block
hours. Default is 12 blocking hours.
23-I. CAPTION LOCK
Set to 1 to restore previous caption On/Off state after TV turns
off. When set to 0, captions are always off, when TV is initially
turned on.
24-I. TEXT MODE
Determines whether TEXT 1, TEXT 2, TEXT 3, or TEXT 4 decoding is
enabled when TEXT is turned on (either from the Setup Menu or
directly with CC on the remote).
TIP: Set Text Mode to 1 only if text is offered in your video
system.
25-I. NOT USED
26-I. NOT USED
27-I. NOT USED
28-I. CH. OVERRIDE (Channel Override)
When set to 1, the user can select channels with either Channel
up/down or by direct number keypad entry. When set to 0, only
those channels that are entered for scanning may be selected by
keypad entry. Note: If set to 0, Auto Program is locked; (as shown
on Setup menu) channel search is not available.
29-I. NOT USED
30-I. NOT USED
31-I. NOT USED
32-I. NOT USED
33-I. NOT USED
34-I. NOT USED
35-I. NOT USED
36-I. NOT USED
37-I. NOT USED
38-I. NOT USED
39-I. NOT USED
40-I. AUTO CAMPORT
Set to 1 to automatically switch to Camport when equipment is
connected to front Video input.
Set to 0 to disable front Video automatic source selection.
Installer Menus
Installer Menu Items 14-I through 40-I: Detailed Descriptions