Zenith M52W56LCD Flat Panel Television User Manual


 
PAGE 48
206-04006
Programming the Remote
Test your remote control.
To find out whether your remote control can
operate the device without programming,
turn on the device such as a the VCR and
press the corresponding mode button (VCR)
on the remote control while pointing at the
device. Test the POWER and CH +/- buttons
to see if the device responds properly. If
not, the remote requires programming to
operate the device.
Turn on the device to be programmed. Then
press the corresponding mode button on the
remote control.
Press the POWER button and the MUTE but-
ton simultaneously. Now the remote control
is ready to program the code for the corre-
sponding device.
There are two ways to find the right code for
the device.
A. If you press the CH +/- buttons repeat-
edly, the codes will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
Test the remote control functions to see if
the device responds properly. If not, repeat
from step 2.
1
1 2 3
4 5 6
7 8 9
0
TV
MODE
LIGHT
POWER
TV/VIDEO
DVI
RGB
VCR
CABLE
DVD
SAT
MUTE
SWAPPIPCH- PIPCH+
PIP
RATIO
RECORD
STOP
PAUSE
REW
PLAY
FF
MENU EXIT
CC FREEZE
PIP INPUT
VOL
CH
SURF
SAP
VIDEO
COMP2COMP1
SIDE
SKIP
ENTER
FLASHBK
2 3
4
5
3
2
3
4
5
6
4
The remote control for your HD receiver is a
multi-brand or universal remote control that can
be programmed to operate most remote-control-
lable devices of other manufacturers.
Note: The remote control may not be able to con-
trol all models of other brands.