Filter
Top Products
REMOTE CONTROL MODEL MBR3430
PREPARATION FOR USE
Batteries are provided with this remote, but you must install
them before using the remote.
INSTALLING BATTERIES
When the effective operating range of your remote becomes
noticeably shorter, replace the batteries with two high-quality,
alkaline, size AAA batteries.
Zenith is not responsible for damage caused by battery
leakage.
After installing new batteries, the remote control will set itself
to Zenith brand codes, as follows:
TV=1
0 I, VCR=20 1 and
CABLE=30 1.
If you are going to operate equipment that uses different
codes, the remote must be reprogrammed for those codes.
AUTO FIND MODE
Use Auto Find to automatically find the brand code needed to
operate your equipment
L)
NOTE:
If no button is pressed for 60 seconds or more during
Auto Find, the remote will automatically exit Auto Find
without storing any brand codes.
(LEDs
will flash 3 times
upon exiting.)
1.
Turn on the equipment you wish the remote to oper-
ate.
2. Press and hold LEARN until mode indicator lights
(about 4 seconds).
3.
Use MODE to select the mode you wish to program
(TV, VCR or CABLE).
4.
Enter “00” then press ENTER within 2 seconds. All four
mode indicator lights will turn ON and then OFF, leaving
the mode indicator light for the active mode ON.
5.
Point remote towards the equipment.
6.
Press and release OFF/ON on the remote about once every
second, until the equipment turns OFF. Press ENTER
before pressing any other buttons.
If you press OFF/ON again before pressing ENTER
Auto Find will have to be repeated.
7.
Try other buttons to see if they operate the equipment.
If they do not, you may wish to reenter Auto Find and
try to find another code. The remote will begin with
codes starting from where it left off prior to exiting
Auto Find.
-
_
___--
-
-
//
CHANNEL ,
~-----_
.
-
3-lII
’
~
g(g
L--1
I
CABLE-TV DECODER
i
8.
Repeat Auto Find for each piece of equipment you want
your remote to operate. NOTE: Only one brand code can
be programmed in each of the four modes.
If no brand code has been entered after searching through all
brand codes in any mode, the remote will flash all four mode
indicator lights in a chasing manner. Wait 60 seconds or press
ENTER or LEARN to return to normal operation.
2736-O
4-5