Filter
Top Products
REMOTE CONTROL MODEL MBR3430
PROGRAMMING BRAND CODES
Introduction
Before using your new remote control, it must be programmed
to recognize the brands of equipment it will be used to
operate.
If you are using a Zenith VHS VCR or a Zenith
cable-TV decoder, the remote has already been programmed
for you.
Find the code that corresponds to each brand and type of
equipment you are going to operate. Refer to Tables 1,2 and 3.
For example, if you were programming the remote for use
with a Zenith TV, you would look for “Zenith” in “Table I”,
and find code “101.”
Write the brand codes for your equipment on the following
lines.
TV CODE:
CABLE CODE:
-
VCR CODE:
1.
2.
3.
4.
5.
6.
Press MODE repeatedly to select the desired TV,
VCR or CABLE operating mode for the remote.
Press LEARN for about
5
seconds until the MODE
indicator lights for the selected TV, VCR or CABLE
mode of operation.
Enter the proper brand code number for the equipment
to be controlled.
Press LEARN. All three mode indicators should light
briefly, then turn off to indicate the brand code has
been programmed.
If all three mode indicators fail to light briefly, an
error has occurred. Repeat Steps 1-4 to try again.
Repeat steps
1-4
to program the remote for the other
equipment you are using.
NOTE: CABLE mode can be programmed to operate a
second TV or second VCR, if desired.
When batteries are removed: It will be necessary to reprogram
the proper VCR and cable-TV decoder codes.
Operating Mode
Indicators
Numbered Buttons
Use to enter code number
for desired brand.
LEARN Button
1
~c3~~
SWAP
TIMER
SEQ
CCDCIDCD
RECORD STOP
PAUSE
SEARCH
a3cEB~cz3
REW PLAY
F FWD TVNCR
.
Operating MODE Selector
2736-O
4
-6