Zenith R50W47 Flat Panel Television User Manual


 
8 Projection TV
Introduction
- When using the remote control, aim it at the remote control sensor on the TV.
Installing Batteries
Open the battery compartment cover on the back side and install the batteries
matching correct polarity (+ with +, - with -).
Install two 1.5V AA batteries. Dont mix old or used batteries with new ones.
Replace cover.
Remote Control Key Functions
Remote Control Key Functions
1 2 3
4 5 6
7 8 9
0
tv
vcr
cable
dvd
sat
mode
light
power
tv/video
comp/dvi
front
freeze
signalratio
dash(-)
flashbk
mute
surf
audio
video
vol
ch
pip inputpipch- pipch+
pip
info
timer cc
swap
menu exit
recordstop
pause
rew
play
ff
skip
MODE INDICATOR LIGHTS
Show active remote mode every time any
button is pressed.
MODE
Selects the remote operating mode: TV,
VCR, Cable Box, DVD, or Satellite.
Select other operating modes, for the
remote to operate external devices.
TV/VIDEO
Selects: DTV, Analog, Video1-2,
Front Video, Video4, Component 1-2,
and DVI input sources.
RATIO
Changes the aspect ratio.
MUTE
Switches the sound on or off.
VOLUME UP/DOWN
Increases/decreases the sound level.
INFO
When you watch the TV, displays informa-
tion on top of the screen. Not available in
Component 1-2, RGB and DVI mode.
TIMER
Lets you select the amount of time before
your TV turns itself off automatically.
THUMBSTICK (Up/Down/Left/Right/OK)
Allows you to navigate the on-screen
menus and adjust the system settings to
your preference.
MENU
Brings up the main menu to the screen.
DASH
Used to enter a program number for multiple
program channels such as 21,22,etc.
NUMBER buttons
POWER
Turns your TV or any other programmed
equipment on or off, depending on mode.
FRONT
Selects the front video input sources.
COMP/DVI
Selects: Component 1-2, and DVI input
sources.
FREEZE
Freezes the currently-viewed picture. Main
picture is frozen in PIP/Twin picture mode.
FLASHBK
Tunes to the last channel viewed.
SURF
Use to scroll the Surf channel list.
VIDEO
Adjusts the factory preset picture according
to the room.
CHANNEL UP/DOWN
Selects available channels found with EZ
scan.
SIGNAL
Displays the digital signal strength.
PIP
Switches between PIP, POP (Picture-out-of-
Picture) and Twin picture modes.
PIPCH-/PIPCH+
Changes to next higher/lower PIP channel.
PIP INPUT
Selects the input source for the sub picture.
SWAP
Exchanges the PIP/main images.
CC
Select a closed caption: Off, EZ Mute,
and On.
EXIT
Clears all on-screen displays and
returns to TV viewing from any menu.
AUDIO
Selects MTS sound: Mono, Stereo, and SAP.
Change the audio language in DTV mode.
LIGHT
Illuminates the remote control buttons.
VCR/DVD BUTTONS
Control some video cassette recorders or
DVD player ("RECORD" button is not avail-
able for DVD player).