A SERVICE OF

logo

Open as PDF
next previous
2–Pump 12-Station Controllers Chapter 8: Service Only Information 59
SET PUMP STAGE TIME?
NO/YES
STAGE DELAY: 3.000s
PRESS ENTER TO SAVE
Setting the Pump Stage Time
Pump stage time is a delay that prevents both pumps from engaging at the same time.
Although rare in a two-pump system, both pumps can sometimes start at the same time. This
condition causes an excess of current on the electrical system from such a surge.
The pump stage time delay defaults to 3.0 seconds and should not be altered unless you are
instructed to do so by the Service Dept.
At the above message prompt:
1. Press the YES key to enter the Pump Stage Time menu.
Using the keypad:
2. Enter the new time and press the ENTER key to save the new setting.